A higher quality spring greatly improves the performance of your coil shock. VALT springs from Cane Creek are much lighter than traditional steel springs while pushing the boundaries of performance and durability. - Inner diameter of 36.5mm is compatible with all Cane Creek coil shocks - Also compatible with Manitou, Marzocchi, XFusion, ELKA/MRP, BOS and DSP - Compatible with Fox coil shocks with required spring clip adaptor
$48.00 - $72.00
Replacement springs for Cane Creek Helm suspension forks.
Slamset top headsets are designed to keep the stack height low. - Hellbender bearings with improved seal structure
$34.00 - $63.00
Hellbender bearings have an improved seal structure and are cross compatible with Cane Creek headsets.
Rebuild kits come with everything you need to service moving parts on a Cane Creek Thudbuster suspension seatpost. - Rebuild bushing tools - LT arm screws (M4 x 20mm) - Saddle clamp bolt (M5 x 35mm) - Saddle clamp spherical washers - Saddle clamp adjustment knob
The OPT remote allows instant engagement of Cane Creek's Climb Switch on Double Barrel rear shocks, giving the rider precise control of traction and climbing feel. - Hard anodized for durability - Requires brake cable and housing for installation - Bottom mount for below bar engagement or top mount for above bar - Compatible with DBinline, DBAir IL, and DBCoil IL shocks only
$28.00 - $32.00
Mounting hardware fits a variety of Cane Creek shocks.
Replacement top subassemblies are compatible across Cane Creek 110-, 40-, and 10-Series headsets with the same SHIS values. - Bearings not included - Stack height = 9mm
$21.00 - $22.00
Cane Creek's Thud Glove protects the moving parts of your Thud Buster seatpost from dirt and weather. Available in both short- and long-travel models.
Replacement elastomers for Thudbuster ST suspension seatposts allow the rider to tune for weight.
Allows the lower of a 47mm IS headtube to be converted to use a standard 41mm 36x45 degree headset bearing.
Replacement top subassemblies are compatible across Cane Creek 110-, 40-, and 10-Series headsets with the same SHIS values. - Bearings not included - Stack height: 9mm
Installation of air volume reducers for Cane Creek shocks make the spring rate more progressive. - Spacers can be cut to fine-tune spring curve
Replacement elastomers for Thudbuster LT suspension seatposts allow the rider to tune for weight.
- Enables Double Barrel springs (1.43" ID x 2.10-2.19 OD) to be run on other brand shocks
Interlok spacers nest into the lip of Cane Creek headset uppers for a rock solid, flex-free fit. - Composite construction
Page 1 of 1